If a sensor is not configured correctly, then it will need adjustementadjustment. Changing the configuration is done through the azeti Control Panel.
...
In this case we will change the rounding precision from 2 to 1, because there is no need to see the degrees in such detail.
Step-by-step guide
- Go to Config/Provisioning → Sensor Templates → Site Templates
- Click on Edit next to the correcponding Site Template
- Toggle SU/Normal Mode and clkick on the +Sensors to colapse it
- Click on the desired sensor. In this case Temperature
- In the field sensor.sensor_gateway.calibration_rule.rounding_precision.value change the value to 1
- Toggle SU/Normal Mode and clkick on back
- Now the Site Template needs to be redployed for the changes to take effect → How to deploy a Site Template
...
| Info |
|---|
Raw Result Factor is a calculated value, depending on the values we get from the I/O module and the temperature range the sensor can measure. In this case, the I/O module gives a value ranging from 0-32767. This needs to be divided by the range the temperature sensor can measure (-50-150°C). |
Related articles
| Filter by label (Content by label) | ||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
...