Page Comparison

...

1. Remove any pre-installed versions of SONARMANAGER via Windows Control Panel (old configuration data persist through this step)
2. Install provided SONARMANAGER 2.7.4.5 (or higher)
3. Close SONARMANAGER if startet started after installation

4. Copy provided Custom Uploads-extention to the following path:

   No Formatinfo
   C:\Users\%USERPROFILE%\Documents\azeti\SonarManagerPlugins\

5. Start SONARMANAGER

   Info
   This adds the new option "Custom Uploads" in the context menu of any appliance.

...

1. Open a browser

2. Connect to the appliance's AdminGUI

   No Formatinfo
   http://<ip-address>:81

3. Select Status::Summary

4. Check if the first line reads your new SysID

   No Formatinfo
   Your appliances machine id is 1m005056000948, which is a production version.

5. Select System::License

6. Check if the first line reflects the amount of host licenses:

   No Formatinfo
   License: Maximum number of defined hosts: 200

7. Open SONARMANAGER

8. Right click on your appliance
9. Select "netconf"

10. Check the amount of shown interfaces

    Info
    Keep in mind that the first interface (usually eth0) is not shown in this list since it is configured via serial console or SONARPLEX AdminGUI. Example: A license for four ethernet interfaces will just show you eth1-3

...

1. Open SONARMANAGER
2. Right click on the appropriate appliance
3. Select "Custom Uploads"

4. Find the line reading the machine file

   No Formatinfo
   1m005056000948.tar [-]

5. Click on [  -  ] to remove machine file

6. Reboot appliance