Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Section
Column

Settings

The following describes the settings for Configuration > Network > SNMP Configuration in detail. 

SettingDescription
Trap Agent Port

TCP Port to listen for traps

Trap Agent Debug Level

Level of debug detail starting from nothing (OFF) up to heavy debug (TRACE) . The log can be found in

Excerpt Include
_AdminWeb
_AdminWeb
nopaneltrue
> Logs > SNMP Processor

Trap OID Output Format

Format of the corresponding trap OID, can be fully numeric up to symbolic.

Note

The Trap Filters are fully dependent on this setting, e.g. if you configured trap filters to match on numeric OIDs, you must set numeric OIDs as format here too. Otherwise the trap filters won't apply anymore.

Max number of trap history entries

Number of last traps that should be saved in the trap history database, see

Excerpt Include
_AdminWeb
_AdminWeb
nopaneltrue
> Trap Filters

Trap community authorization stringCommunity string for authentication of incoming SNMP traps
Agent community stringCommunity for SNMP Agent (SNMP GET)
Agent sysName ValueSystem name, OID:  iso.org.dod.internet.mgmt.mib- 2.system.sysName.0
Agent syslocation ValueSystem location, OID:  iso.org.dod.internet.mgmt.mib- 2.system.sysLocation.0
Agent syscontact ValueSystem contact, OID:  iso.org.dod.internet.mgmt.mib- 2.system.sysContact.0
Column
width300px
Panel
bgColor#f4f4f4
borderStylesolid

On this page:

Table of Contents