...
| Code Block |
|---|
<component_template config_version="1.0" schema_version="1.0">
<description>template_Adam_4051</description> # This is the general description respectivly the name of the Template.
<vendor>azeti</vendor>
<version>2</version>
<class>multi-sensor</class>
<sensors>
<sensor sensor_id="DI00"> # This is the name of the sensor as it will be shown in the Dashboard.
.
.
.
</sensor>
.
.
.
<devices>
<device device_id="ADAM-4051"> # Name of the device.
<modbus_device pdu_addressing="false"> # Wheter or not, PDU addressing is turned on or off. Respectively if the register starts from 0 (true) or 1 (false).
<modbus_rtu> # What ModBus type we are using. Possible options are ModBusRTU and ModBusTCP.
<daemon_id>0</daemon_id> # This is the serial interface to be used, configurable in the SiteController.cfg (See Link below).
<data_bits>8</data_bits> # Databits used by the device (default is 8).
<stop_bits>1</stop_bits> # Stopbits used by the device (default is 1).
<baud_rate>9600</baud_rate> # Baudrate used by the device.
<parity>none</parity> # Parity used by the device.
<slave_address>1</slave_address> # Slave address used by the device.
</modbus_rtu>
</modbus_device>
<sensor_gateways>
<sensor_gateway sensor_gateway_id="ADAM-4051" publish_strategy="on_change"> # Here we define the name of the gateway, so the sensor knows which one to use.
# Additionally we can change how the sensor data will be sent to the server.
# Possible options: never, on_change, interval, always.
<modbus> # In some cases, it is required to use multiple gateways. Exmaple below.
<modbus_register>
<register_address>1</register_address> # This is the the first register address of the device.
<register_count>16</register_count> # Here we tell the system, how many registers the device has. In this case 16, because the Adam has 16 inputs.
<block_type>coils</block_type> # Here we define what kind of type these registers are (Ex. coils, holding registers, input registers).
</modbus_register>
<scheduling>
<polling_interval>200</polling_interval> # Here we define how often the registers should be polled. The value 200, is equal to 0.2 seconds.
<error_handling>
<retry retry_algorithm="linear"/>
</error_handling>
</scheduling>
</modbus>
</sensor_gateway>
</sensor_gateways>
</device>
</devices>
</component_template> |
...