Install new machine files to change the licensed amount of allowed hosts or ethernet interfaces to configure in Sonarplex or to change SysID. Requires Sonarmanager SONARMANAGER 2.7.4.5 (or greaterhigher).
Preperations
Install Sonarmanager 2SONARMANAGER 2.7.4.5 (or greaterhigher) and add the Custom Uploads-extention to allow Custom Uploads.
- Remove any pre-installed versions of Sonarmanager via SONARMANAGER via Windows Control Panel (old configuration data persist through this step)
- Install provided Sonarmanager 2SONARMANAGER 2.7.4.5 (or greaterhigher)
- Close Sonarmanager if runningSONARMANAGER if startet after installation
Copy provided Custom Uploads-extention to the following path:
No Format C:\Users\%USERPROFILE%\Documents\azeti\SonarManagerPlugins\
Start SonarmanagerStart SONARMANAGER
Info This adds the new option "Custom Uploads" in the context menu of any appliance.
Install Machine File
- Open SonarmanagerOpen SONARMANAGER
- Right click on the appropriate appliance
- Select "Custom Uploads"
- Select "Add SysIdFile"
- Search for your machine file
- Hit Click "Upload" in the lower right corner
- Reboot appliance
...
Expected results
- Open a browser
Connect to the appliance's AdminGUI
No Format http://<ip-address>:81
- Select Status::Summary
Check if the first line reads your new SysID
No Format Your appliances machine id is 1m005056000948, which is a production version.
- Select System::License
Check if the first line reflects the amount of host licenses:
No Format License: Maximum number of defined hosts: 200
Open SonarmanagerOpen SONARMANAGER
- Right click on your appliance
- Select "netconf"
Check the amount of shown interfaces
Info Keep in mind that the first interface (usually eth0) is not shown in this list since it is configured via serial console or Sonarplex AdminGUI. Example: A license for four ethernet interfaces will just show you eth1-3
...
Warning |
---|
This will remove the installed tar file but won't undo the changes done by machine file installation! To change these, another machine file with the desired information must be uploaded. |
- Open SonarmanagerOpen SONARMANAGER
- Right click on the appropriate appliance
- Select "Custom Uploads"
Find the line reading the machine file
No Format 1m005056000948.tar [-]
Click on [ - ] to remove machine file
- Reboot appliance